The Right Ways to Maintain Saw Blades

It only needs a little effort to significantly increase the service life of a circular saw blade. Care not only includes sharpening but also very simply cleaning the flanks and teeth.

Regular cleaning

Deposits have a tendency to adhere to circular saw blades, particularly after cutting resinous softwood. The liquid tree resin stays with the saw blade and also mixes with the great dirt of the fresh sawn wood. By disregarding to thoroughly clean up the saw blade, the resin and timber combination solidifies and creates a harsh surface area on the sides of the saw blade. When the saw blade is made use of the next time, these hard down payments cause more rubbing therefore more warmth on the cutting side. The outcome is unpleasant to burn marks on the wood, which later on have to be tediously sanded out once again. This annoying phenomenon can conveniently be avoided by routine cleansing the saw blade. All you need is the lid of an old paint bucket, a cord brush, and also some dilution. Naturally, the very first step is to remove the saw blade from the circular saw as described by the manufacturer. And normally the table saw has to be detached from the power supply prior to that! So please disconnect the maker and also leave it separated from the power supply until the cleaning is full and the saw blade has been re-installed!

Currently, place the taken apart saw blade on the cover of the paint container so that it remains in the center of the elevated edge. About 100 ml of dilution is ample to clean one blade. Put the dilution over the saw blade and allow it to represent a couple of minutes. Currently, you can get rid of the deposits with a cord brush. Take concerning five mins per side of the saw blade to clean it off appropriately. If you just utilize the dilution to clean saw blades, you can use a funnel to return the excess dilution to the can and use it again the following time. Your saw blade must currently shine once again as well as be barely distinct from a brand-new saw blade.

Additionally, if you don't have a thinner at home, a routine house cleanser can help you with cleaning up saw blades: Oven spray. Here you spray it just onto both sides of the blade and also remove the liquified dirt with a great brush and water. Yet be careful: The oven cleansing spray is best used outside or with enough fresh air. Likewise don't breathe the vapors indirectly.

Sharpening the saw blade yourself

The ultimate in saw blade care is and remains sharpening it yourself. Saw blades required an appropriate sharpener. All other circular saw blades can easily be sharpened on the workbench with just a few tools. The tools required are quite simply two strips of wood, a screw clamp and a flat file. The dismantled saw blade is clamped between the two strips wood to the work bench with the screw clamp. Not more than one third of the saw teeth should stick out at the top between the two strips of wood. Now place the flat file at the angle of the cutting surfaces on the teeth of the saw blade and pull it back and forth three or four times. Avoid applying pressure to the file, otherwise it may happen that the angle of the cutting edge is not 100 % correct. Now you repeat these steps until each tooth of the saw blade had its turn. The cutting edges of your saw blade should now shine like new again.

We are a saw blades supplier, please feel free to contact us if you need them.